Lucent Technologies 6 - Manual (Page 9)

CRCS/OpCenter and OpCenterSP Checklist
Issue 1 CRCS R6.0 April 1999 5
Pre-Installation Requirements
As a single-user dedicated system on a PC connected to one or two Lucent Tech-
nologies MultiPoint Conferencing Units (MCU), CRCS/OpCenter or OpCenterSP
can be set up as either local or remote.
For a local connection, the distance between the PC and MCU must be less than
5000 feet. Distances beyond 5000 feet are considered remote. Also, if the PC is
not connected to the TN754B or TN2223 on the MCU side, the connection is
remote.
CRCS/OpCenter and OpCenterSP Checklist
Hardware Requirements
The system installed for single-user CRCS/OpCenter must be dedicated for
CRCS/OpCenter use only. The following hardware components are required:
n 266 MHz Pentium II CPU with 64 MB RAM or greater recommended (mini-
mum 100 MHz Pentium with 32 MB RAM)
n 1024 by 768 pixel resolution, 256 color, and small fonts
n One 17-inch monitor (minimum 15 inch)
n 2.5 GB hard disk with a high-speed drive and local bus controller (minimum
1.2 GB)
n One 1.44 MB 3.5 inch floppy disk drive
n One 6X CD-ROM drive (minimum 4X)
n A COM1 serial port with a 25-pin connector or a 9-to-25 pin adapter, if the
COM1 port is 9 pin
n A bus mouse or a serial mouse connected to a COM serial port
n Optional laser or laser-quality printer connected to the LPT1 parallel port
and installed as the default printer
n Optional (highly recommended) backup tape or high capacity removable
disk device and appropriate software for the backup
n Slot for the fax hardware (optional)
Software Requirements
n Microsoft Windows 95 or Windows NT 4.0 workstation with Service Pack 4