What is in this manual – Lochinvar Copper-fin II/IIE 402 - 2072 User Manual

Page 4

Advertising
background image

4

What is in this manual?

Service

The Copper-fin display

• Display panel readout, buttons and their functions

Control module inputs

• Control module inputs and options

Control module outputs

• Control module outputs and options

General

• How the appliance operates
• How the control module operates
• Access modes -- user and installer
• Sequence of operation -- Domestic Hot Water
(DHW)/space heating

Control panel menu access

• Accessing programming mode and locating menus
(See separate guides covering the ModBus and PC interfaces)

Control panel parameter access

• Accessing and changing parameters from the display panel

Quick start information -- parameter tables

• An index of available adjustments and readouts, where to
access them and where to find detailed information.

Maintenance

• Service and maintenance schedules
• Address reported problems
• Inspect appliance area and appliance interior
• Check all piping for leaks
• Flue vent system and air piping
• Combustion air filter
• Check water system
• Check expansion tank
• Check relief valve
• Check igniter
• Check all appliance wiring
• Flame inspection
• Check flue gas passageways
• Inspect and clean burner
• Checking combustion air pressure
• Checking manifold gas pressure
• Cleaning heat exchanger
• Review with owner

Troubleshooting

• Troubleshooting table - No display
• Checking temperature sensors
• Troubleshooting table - Noisy system
• Troubleshooting table - Fault messages displayed on
Operator Interface

Copper-fin II/IIE Boiler and Water Heater

Service Manual

Copper-fin boiler operation

(pages 13 - 14)

• A: General
• B: Temperature Settings
• C: Data Logging
• D: Functions
• E: DHW Settings
• F: Outdoor Air Reset
• G: Anti-cycling
• H: Control Modes
• I: Cascade
• J: Building Management System (BMS)
• K: Pumps
• L: Service Notification

Copper-fin water heater operation

(pages

15 - 16)

• A: General
• B: Temperature Settings
• C: Data Logging
• D: Functions
• E: DHW Settings
• F: Anti-cycling
• G: Control Modes
• H: Cascade
• I: Building Management System (BMS)
• J: Pumps
• K: Service Notification

Advertising