Lincoln Electric POWER MIG SVM167-A - Manual (Page 66)

F-30 TROUBLESHOOTING AND REPAIR F-30
POWER MIG® 215
PROCEDURE
1. Remove power to the machine.
2. Lift cover to gain access to the wire drive.
See Figure F.9.
3. Using a pair of pliers, disconnect the gas
hose from the bottom of the wire drive.
See Figure F.10.
4. Using a 9/16” nut driver, remove the thick
black positive lead located just above the
gas hose. See Figure F.10.
NOTE: Disconnect lead from the wire drive
motor assembly, not the machine.
5. Using a 5/16” nutdriver, remove the three
mounting screws next to the wire drive
assembly. See Figure F.10.
6. Using a 5/16” nutdriver, remove the two
screws on the case front assembly. See
Figure F.11.
7. Carefully maneuver the wire drive assem-
bly out the side of the machine to gain
access to plug J4. See Wiring Diagram.
8. Disconnect plug J4.
WIRE DRIVE MOTOR ASSEMBLY REPLACEMENT (Continued)
Wire Drive
FIGURE F.9. - WIRE DRIVE LOCATION
Return
to
Section
T
OC
Return
to
Section
T
OC
Return
to
Section
T
OC
Return
to
Section
T
OC
Return
to
Master
T
OC
Return
to
Master
T
OC
Return
to
Master
T
OC
Return
to
Master
T
OC