Lucent Technologies Network Access Module - Manual (Page 19)

INA Module 1-3
INA Front Panel
Figure 1-1 INA Module Front Panel
DIP Switches. DIP switch 1 controls the configuration of serial port C0. DIP switch 2
controls ComOS boot behavior. See “Set DIP Switches” on page 3-2.
System LED. This LED indicates the status of the routing hardware and the ComOS.
One blink every 5 seconds indicates normal operation. See “System LED” on page 3-5.
C0 Serial Port. This RJ-45 connector is used to connect a PC or terminal to act as a
console. The console is used to access the ComOS command line interface. See “Connect
a Console (Optional)” on page 3-3.
Network Activity LED. This amber LED blinks to indicate network traffic. See
“Ethernet LEDs” on page 3-6.
DS-1 status LEDs
C1 serial port
console port (C0)
Ethernet port (Ether 0)
Reboot button
T1/PRI port
DS-1 test jacks
DIP switches
system LED
network activity LED
Ethernet link LED
1210-001