Set the system name, Set the default route gateway, Use name resolution (optional) – Lucent Technologies Network Access Module User Manual
Page 36: Set up a local host table, Set a name service, Set the system name -4, Set the default route gateway -4, Use name resolution (optional) -4, Set up a local host table -4, Set a name service -4
Advertising
Set the System Name
5-4
INA Module Installation and Configuration Guide
Set the System Name
The system name identifies the INA module for Simple Network Management Protocol
(SNMP) queries, IPX protocol routing, and Challenge Handshake Authentication
Protocol (CHAP) authentication.
Use these commands to set the system name:
Command> set sysname String
Command> save all
The system name can have up to 16 characters. When the system name is set, it replaces
the word Command in the prompt.
Set the Default Route Gateway
The default gateway address is the destination address to which the INA module sends
the packet when its
Advertising