Lucent Technologies Network Access Module - Manual (Page 27)

Installing the INA Module 3-3
Connect Cables
When DIP switch 2 is set to the left (Figure 3-2), and the INA module is turned on,
the INA module boots (loads the ComOS software) from the internal nonvolatile
RAM. This is the default setting for the module.
When DIP switch 2 is set to the right, and the INA module is turned on, the module
boots from an external BOOTP and TFTP server. Use this setting only when serious
hardware or software problems have occurred. You should only use this DIP switch
setting under the direction of Lucent technical support personnel.
Connect a Console (Optional)
You can connect a PC or terminal to the INA module’s console port (Figure 3-3) to
access the command line interface of ComOS.
Figure 3-3 Console Port Connection
Follow these instructions to connect a PC or terminal:
1. If necessary, ensure that your PC or terminal has the same settings as the
console port on the INA module.
The settings are 9600 baud, 8 data bits, 1 stop bit, no parity, and no flow control.
2. Connect a console cable to the C0 port of your INA module and PC or
terminal (Figure 3-3).
See “Console Cable” on page B-1.
3. Reboot the INA module by pressing the recessed reboot button. Verify that
the login prompt appears.
Connect a T1/PRI Cable
Use a category 5 twisted pair cable, as specified by the EIA/TIA-568-B wiring standard,
with an RJ-48C connector to connect to the T1/PRI line (Figure 3-4). See “T1/PRI
Cable” on page B-2 for more information.