Lucent Technologies Network Access Module - Manual (Page 30)

Observe LED Behavior
3-6 INA Module Installation and Configuration Guide
After the module has been powered up and loading is complete, make sure that the LED
is blinking off once every 5 seconds. The INA module takes about 20 seconds to reach
this state.
Ethernet LEDs
These LEDs (Figure 3-8) show the status of the Ethernet connection to the INA module.
Figure 3-8 Ethernet LEDs
• The green link LED is on when the module has link integrity to a 10BaseT hub,
switch, or router. Make sure that this LED lights when a cable has been connected
between the module and an Ethernet hub. If the LED does not light, check the cable
itself and the network connections.
• The amber network activity led blinks to indicate Ethernet traffic. During heavy
traffic, this LED might appear solid due to its rapid blinking. Depending on your
network, you might not necessarily see much traffic.
network activity LED Amber
Green Ethernet Link LED
1210-006
E
T
H
E
R
N
E
T