Lucent Technologies Network Access Module - Manual (Page 24)

Network Settings
2-4 INA Module Installation and Configuration Guide
DLCI list For Frame Relay connections for which
you manually enter a list. Enter each
DLCI number (1 to 1023), a colon (:),
and the IP address of the router
represented by the DLCI. 16:172.26.131.37
Dynamic Host Connection
Protocol (DHCP) server
address If you use DHCP. Defaults to Ether0. 192.198.32.17
DHCP lease time For DHCP dynamically assigned IP
addresses. Enter hours and/or minutes.
A 0 (zero) indicates an infinite time. 8 hours
DHCP static binding IP
address(es) and corresponding
media access control (MAC)
address(es) For DHCP statically assigned IP
addresses. Enter each IP address and
the 12-digit hexadecimal MAC address
of the host to which it is assigned. 192.198.32.33
00:c0:d5:d4:da:2c
DHCP address pool start
address For DHCP dynamically assigned IP
addresses. Enter one address or the first
in each address range. 192.198.32.65
DHCP address pool end
address Enter the last address in the range. 192.198.32.127
Network address translator
(NAT) secure address and
corresponding nonsecure
address If you use NAT static maps. Enter each
secure internal (private) IP address and
the nonsecure external (global) IP
address to which you want it mapped. 192.198.32.22
172.18.1.1
NAT base IP address For a NAT dynamic address pool. Enter
one nonsecure external (global) IP
address or the first address in a range. 192.198.32.2
NAT pool size For a NAT address pool range. Enter a
number of IP addresses up to 64. 64
Table 2-2 Basic Network Configuration Settings for the INA Module (Continued)
Settings Notes Example