Troubleshooting and repair, Output filter board – Lincoln Electric INVERTEC SVM161-A User Manual
Page 102
Output Filter Board
FIGURE F.32 – OUTPUT FILTER BOARD LOCATION
OUTPUT FILTER BOARD
REMOVAL AND REPLACEMENT (continued)
PROCEDURE
1. Remove input power to the V205-T.
2. Using a phillips head screwdriver, remove the
case wraparound cover.
3. Perform the Input Filter Capacitor Discharge
Procedure detailed earlier in this section.
4. Using a phillips head screwdriver, remove the
four
screws
at
the
corners
of
the
nameplate/keypad. See Figure F.33.
5. Gently pull the Control/Display board assembly
forward and up to gain access to the two case-
front mounting screws located beneath. See
Figure F.33.
NOTE: There is no need to disconnect any leads
from the P.C. boards located behind the
nameplate/keypad.
6. Remove the two phillips head casefront mount-
ing screws located behind the metal display
plate. See Figure F.33.
7. Remove the four phillips head screws located
around the output terminals on the lower front of
the machine. See Figure F.33.
8. Carefully manipulate the casefront off of the
machine.
TROUBLESHOOTING AND REPAIR
F-62
F-62
INVERTEC® V205-T AC/DC™