Lincoln Electric INVERTEC SVM161-A - Manual (Page 90)

INPUT FILTER BOARD
FIGURE F.24 – INPUT FILTER BOARD LOCATION
S/L1
R/L1
FIGURE F.25 – INPUT FILTER BOARD LEADS
INPUT FILTER BOARD REMOVAL AND REPLACEMENT (continued)
PROCEDURE
1. Remove input power to the V205-T.
2. Using a phillips head screwdriver remove the
case wraparound cover.
3. Perform the Input Filter Capacitor Discharge
Procedure detailed earlier in this section.
4. Locate the input filter board. See Figure F.24.
5. Using a 7mm nut driver, label and remove leads
R/L1 and S/L2 from the upper right corner of the
input filter board. See Figure F.25.
6. Using a 7mm nut driver, label and remove leads
RV1 and RV2 from the left side of the main
IGBT board. See Figure F.26. See Wiring
Diagram
TROUBLESHOOTING AND REPAIR F-50 F-50
INVERTEC® V205-T AC/DC™
Return
to
Section
T
OC
Return
to
Section
T
OC
Return
to
Section
T
OC
Return
to
Section
T
OC
Return
to
Master
T
OC
Return
to
Master
T
OC
Return
to
Master
T
OC
Return
to
Master
T
OC