Light & Motion DSR-PD150 - Manual (Page 122)

122
Before operation
Insert a recorded “Memory Stick” and a tape to be recorded into your camcorder.
(1) Set the POWER switch to CAMERA.
(2) Press MEMORY MIX in standby mode.
The last recorded or last composed image appears on the lower part of the
screen as a thumbnail image.
(3) Press MEMORY+/– or +/– on the Remote Commander to select the still
image you want to superimpose.
To see the previous image, press MEMORY – or – on the Remote Commander.
To see the next image, press MEMORY+ or + on the Remote Commander.
(4) Turn the SEL/PUSH EXEC dial to select the desired mode.
The mode changes as follows:
M. CHROM
y M. LUMI y C. CHROM y M. OVERLAP
(5) Press the SEL/PUSH EXEC dial.
The still image is superimposed on the moving picture, and your camcorder is
in standby mode.
(6) Turn the SEL/PUSH EXEC dial to adjust the effect.
(7) Press START/STOP to start recording.
Superimposing a still image in a “Memory Stick” on a moving
picture – MEMORY MIX
2
4
5
6
7
M. LUMI
M. LUMI
I I I • • • •
I • • • • • •
3
M. CHROM
M. LUMI
POWER
OFF (CHG)
CAMERA
MEMORY
VCR
1 POWER
OFF (CHG)
CAMERA
MEMORY
VCR
MEMORY MIX
– +
100-0019 100-0019
100-0019 100-0019
100-0019 100-0019
100-0019 100-0019
100-0019
100-0019
100-0019
100-0019
Still image