Light & Motion DSR-PD150 - Manual (Page 78)

78
Dubbing only desired scenes - Digital program editing
(6) Press the SEL/PUSH EXEC dial, or MARK on the Remote Commander.
The CUT-IN point of the first program is set, and the top part of the program mark
changes to light blue.
(7) Search for the end of the first scene you want to insert using the video operating
buttons, then pause playback (p. 29).
(8) Press the SEL/PUSH EXEC dial, or MARK on the Remote Commander.
The CUT-OUT point of the first program is set, then the bottom part of the program
mark changes to light blue.
(9) Repeat steps 5 to 8, then set PROGRAM.
When the program is set, the program mark changes to light blue.
You can set a maximum of 20 programs.
On a blank portion of the tape
You cannot set CUT-IN or CUT-OUT on a blank portion of the tape.
Erasing the last program
To change the end of the last program, delete the CUT-OUT mark.
To erase the whole program, delete both the CUT-IN and CUT-OUT marks.
(1) Turn the SEL/PUSH EXEC dial to select UNDO, then press the dial.
(2) Turn the SEL/PUSH EXEC dial to select EXECUTE, then press the dial.
The last set program mark flashes, then the setting is canceled.
To cancel erasing
Select RETURN in step 2, then press the SEL/PUSH EXEC dial.
7 6
STOP PLAY REW FF PAUSE
MARK
UNDO
ERASE AL L
START
00:08:55:06
1 OUT
SCENE 0
V I DEO ED I T
[MENU] : END
8,9
MARK
UNDO
ERASE AL L
START
00:09:07:06
2 I N
SCENE 1
V I DEO ED I T
MARK
UNDO
ERASE AL L
START
00:10:01:23
4 I N
SCENE 3
V I DEO ED I T
[MENU] : END [MENU] : END