Light & Motion DSR-PD150 - Manual (Page 75)

Editing
75
Dubbing only desired scenes - Digital program editing
Preparation 2: Adjusting the synchronization of the VCR
You can adjust the synchronization of your camcorder and the VCR.
Remove the cassette from the camcorder beforehand. We recommend that you prepare
a pen and paper for notes.
When you connect to a Sony VCR using an i.LINK cable (DV connecting cable), the
setup below is not necessary.
(1) Insert a recordable tape into the VCR.
(2) Set the POWER switch to VCR.
(3) Press MENU to display the menu.
(4) Turn the SEL/PUSH EXEC dial to select
, then press the dial.
(5) Turn the SEL/PUSH EXEC dial to select EDIT SET, then press the dial.
(6) Turn the SEL/PUSH EXEC dial to select ADJ TEST, then press the dial.
(7) Turn the SEL/PUSH EXEC dial to select EXECUTE, then press the dial.
CUT-IN and CUT-OUT are recorded on an image for five times each to calculate
the numerical values for adjusting the synchronicity.
The EXECUTING indicator flashes on the LCD screen or in the viewfinder. When
finished, the indicator changes to COMPLETE.
(8) Rewind the tape in the VCR, then start slow playback.
Take a note of the opening numerical value of each CUT-IN and the closing
numerical value of each CUT-OUT.
(9) Calculate the average of all the opening numerical values of each CUT-IN, and the
average of all the closing numerical values of each CUT-OUT.
3
MENU
4-6
ED I T SET
ADJ TEST
“CUT–I N”
“CUT–OUT”
RETURN
[MENU] : END
RETURN
EXECUTE
OTHERS
ED I T SET
ADJ TEST
“CUT–I N”
“CUT–OUT”
RETURN
[MENU] : END
EXECUT I NG
No . 2
I N
+215
OTHERS
ED I T SET
ADJ TEST
“CUT–I N”
“CUT–OUT”
RETURN
[MENU] : END
COMPLETE
OTHERS