Light & Motion DSR-PD150 - Manual (Page 87)

Editing
87
Audio dubbing
Adding an audio sound on a recorded tape
(1) Insert the recorded tape into your camcorder.
(2) Set the POWER switch to VCR on your camcorder.
(3) Locate the recording start point by pressing N. Then press X at the point
where you want to start recording to set your camcorder to the playback pause
mode.
(4) Press AUDIO DUB. The green X indicator appears on the LCD screen or
in the viewfinder.
(5) Press X and start playing back the audio you want to record at the same time.
The new sound is recorded in channels 3/4 during playback.
(6) Press x at the point where you want to stop recording.
Monitoring the new recorded sound
To play back the sound
Adjust the balance between the channels 1/2 (CH1/2) and the channels 3/4 (CH3/4) by
selecting AUDIO MIX in the menu settings (p. 104).
The default setting is for original sound only.
If you set the audio balance beforehand, you can monitor both the original sound and
dubbed sound during the dubbing.
VCR SET
CH SELECT
AUD I O M I X
A/V DV OUT
RETURN
[MENU] : END
CH1
2
CH3
4
AUDIO DUB
POWER