Lanier 5227 - Manual (Page 20)

Configuring Windows 95/98
2 - 6 Windows 95/98 Configuration
Inputting Port Name for use with TCP/IP Protocol
Enter the IP address of the Network Interface Board into the [IP address] box.
•
You can enter the host name or a domain name instead of an IP address into the [Host
Name] box.
•
Limitation: You cannot use a host name that begins with “%%”.
•
When you use DHCP to assign IP addresses to Network Interface Boards, you can use a
printer name (Current Host name on the network configuration page) as the host name.
Inputting Port Name for use with NetBEUI Protocol
Print a configuration page, and confirm the Network path name.
•
For information on printing a configuration page, refer to the Operator Guide for your
printer.
Enter the printer's Network path name in form of “%%Computer name \Share name”. Do not enter
“\\” as head characters but “%%”.
8
Confirm the port name in the [Port Name] box, and click [Finish].
9
In the [Printer Ports] dialog, click [Close].
10
Confirm that the port name is displayed in the [Print to the following port(s)] box and ' mark
is inside the check box. Then click [OK].
•
Configuration is complete.
•
When you print, the printing procedure is no different. When you select the printer
configured here, the computer automatically uses Multi Direct Print.
Uninstalling the Multi Direct Print Application
1
Open [Control Panel], and double click the [Add/Remove Programs] icon.
2
With [Install/Uninstall] tab, select [Lanier Multi Direct Print] by clicking it, and click [Add/
Remove].
3
After a confirmation message appears, click [Yes].
•
UninstallShield removes all of the components of the Multi Direct Print application.
4
When the uninstallation is complete, restart your computer.