Lanier 5227 - Manual (Page 29)

Setting Up a Client Computer
Windows NT 4.0 Configuration 3 - 7
Setting Up a Client Computer
Explanation of this section assumes that the client has already been configured to communicate
with a Windows NT print server. Do not proceed with the following instructions until the client has
been set up and configured correctly.
Windows 95/98
1
Install the printer driver as a local printer.
•
Any port can be selected during the installation, however, LPT1 is recommended.
2
Click [Start], point to [Settings], and then click [Printers].
3
Select the icon of the printer you want to use by clicking it. On the [File] menu, click
[Properties].
4
Click the [Details] tab, then click [Add Port].
5
Click [Network], then click [Browse].
6
On the network tree, double-click the name of the computer used as the print server.
•
The printers attached to the network are displayed.
7
Select the name of the printer you want to use by clicking it, then click [OK].
This section describes the procedures for setting up a client in a network that uses Windows NT
Server or Windows NT Workstation as a print server.
Windows 95/98 Windows NT 4.0
Windows NT 4.0
Print Server
To print from Windows 95/98, you must install the printer driver and change the printer port to
the print server.