Lanier 5227 - Manual (Page 43)

Netware 3.x - Advanced Settings
NetWare Configuration 4 - 9
it, and click [Next].
•
If you do not know which Network Interface Card you are configuring, print the
Configuration Page using the printer's operation panel, and select the MAC
address that is on the page.
6
Confirm that the MAC and IPX addresses are correct, and click [Finish].
•
[NIC Setup Tool] window appears.
7
Click [Configure].
•
The property sheet appears.
8
Click the [NetWare] tab, and make the following settings.
•
In the [Print Server Name] box, enter the name of the print server.
•
In the [File Server Name] box, enter the name of the file server in which a print
server is to be created. Clicking [Browse], you can select a file server among
those listed in the Browse dialog.
•
In the [Print Server Operation Mode] group, click [As Remote Printer].
•
In the [Remote Printer No.] box, enter the printer number. Important Use the
same printer number as that to be created in the printer server.
•
Click [OK] to close the property sheet.
•
After a confirmation dialog appears, click [OK].
9
In the [NIC] menu, click [Exit] to exit the NIC Setup Tool.
10
Enter “PCONSOLE” from the command prompt. F:> PCONSOLE
11
Create a print queue as follows.
•
If you use a currently defined print queue, proceed to the step 12.
•
In the [Available Options] menu, select [Print Queue Information].
•
Press {Insert} and enter a print queue name.
•
Press {Esc} to return to the [Available Options] menu.
12
Create a printer as follows.
•
In the [Available Options] menu, select [Print Server Information].
•
To create a new print server, press {Insert} and enter a print server name. If you
use an currently defined print server, select one of the print servers shown in the
[Print Server] list. Use the same name as that specified in the NIC Setup Tool.
•
In the [Print Server Information] menu, select [Print Server Configuration].
•
In the [Print Server Configuration menu], select [Printer Configuration].
•
Select the printer which is indicated as “Not Installed”. Use the same number as
that specified as Remote Printer No. using the NIC Setup Tool.