Lanier 5227 - Manual (Page 52)

Setting Up a Client Computer
4 - 18 NetWare Configuration
When Using the PostScript Printer Driver
Follow these steps to set up for the PostScript Printer Driver
•
Click the [PostScript] tab.
•
Click [Advanced].
•
Remove the ' marks from the [Send CTRL+D before job] and the [Send
CTRL+D after job] check boxes.
13
Click [OK] to close the property.
Windows 3.1x
Follow these steps to set up a Windows 3.1x client.
1
Install the printer driver of the printer you want to use as “Local printer”.
•
For more information on installing the printer driver, refer to the Operator Guide
for your printer.
2
Double-click the [Printers] icon of [Control Panel].
3
In the [Installed Printers] box, select the printer driver you want to use by clicking it, and
then, click [Connect].
4
In the [Ports] box, click [LPT1] to highlight it, and click [Network].
•
The Network driver dialog appears.
5
In the [Ports] box, click [LPT1] to highlight it, and in the [Resources] box, click the queue
you want to print to highlight it.
•
You should log in to the print server in order to see the print queues.
6
Click [Capture].
•
The specified queue is captured to the LPT1.
7
Click [LPT Settings].
•
The [NetWare Settings] dialog appears.