Lanier 5227 - Manual (Page 35)

Installing the NIC Setup Tool
NetWare Configuration 4 - 1
Installing the NIC Setup Tool
Installing the PRINTER MANAGER FOR ADMINISTRATOR
Follow these steps to install the PRINTER MANAGER FOR ADMINISTRATOR.
You should install the PRINTER MANAGER FOR ADMINISTRATOR on your computer. If you
install it on a file server and execute it via the network, it might not work correctly. Be sure to close
all applications before starting the installation procedure.
1
Insert the CD-ROM that comes with your printer into your computer's CD-ROM drive.
Note: If the installer starts automatically, you can use it to install the PRINTER
MANAGER FOR ADMINISTRATOR, and go to procedure 6.
2
Open [Control Panel], and double click the [Add/Remove Programs] icon.
3
In the [Install/Uninstall] tab, click [Install].
4
Click [Next].
5
Enter the name of the CD-ROM drive in the [command line for installation program] box,
followed by “\NETWORK\PRINTMAN\AD-MIN\ DISK1\SETUP” (do not include the
quotation marks) and then click “Finish”.
Note: An example would be “D:\NETWORK\PRINTMAN\AD-MIN\
DISK1\SETUP” when the drive name is “D”.
6
After the [Welcome] dialog appears, click [Next].
This chapter describes how to configure your printer to use as a print server or a remote printer
in a NetWare environment.
NetWare must be set to active using the operation panel of your printer. For information on how
to set it, refer to the Operator Guide for your printer.
A utility called the NIC Setup Tool is provided to configure your printer to work in a NetWare
environment. Installing the PRINTER MANAGER FOR ADMINISTRATOR, and how to run
the NIC Setup Tool on your computer. This section describes how to install the PRINTER
MANAGER FOR ADMINISTRATOR, and how to run the NIC Setup Tool.
Limitations:
•
NetWare 3.x, 4.x or 5 must be functional to run the NIC Setup Tool.
•
The NIC Setup Tool is supported to work with the following operation systems.
Microsoft Windows 95/98
Microsoft Windows NT 4.0