Lanier 5227 - Manual (Page 7)

Introduction
Introduction 1 - 1
Introduction
Note: The procedures written in this manual assume that you are a network
administrator. Be sure to consult your network administrator before doing any
configuration.
Note: Refer to the manual that comes with the printer for information on
physically installing the Network Interface Board and cabling.
Features
•
Support for 100BASE-TX and 10BASE-T
•
The Network Interface Board is compatible with NetWare (IPX/SPX), Windows NT
(TCP/IP, NetBEUI), Windows 95/98 (TCP/IP, NetBEUI),and Macintosh (AppleTalk)
protocols. This allows you to use the printer in a network that uses different protocols
and operating systems.
•
A computer used as a dedicated print server is not required, because the Network
Interface Board can be configured as a NetWare print server.
•
The Network Interface Board can connect the printer to the network without requiring
its own power supply as the Network Interface Board is installed inside the printer.
This manual contains detailed instructions on configuring your printer for using as a network
printer. The actual procedures may differ depending on your network environment. Use the
procedures for your network environment.