Using setup mode for configuration, Accessing setup mode, Using a telnet connection – Lantronix XPort User Manual
Page 25: Using setup mode for configuration 4-1, Accessing setup mode -1, Using a telnet connection -1, Using setup mode, To the unit’s serial port (ch 1). (see
4
4
:
:
U
U
s
s
i
i
n
n
g
g
S
S
e
e
t
t
u
u
p
p
M
M
o
o
d
d
e
e
f
f
o
o
r
r
C
C
o
o
n
n
f
f
i
i
g
g
u
u
r
r
a
a
t
t
i
i
o
o
n
n
You must configure the unit so that it can communicate on a network with your serial
device. You can configure it using a web browser, as described in
3:Getting Started,
or locally or remotely using the following procedures:
Use a Telnet connection to configure the unit over the network.
Use a terminal or terminal emulation program to access the serial port
locally.
The unit’s configuration is stored in nonvolatile memory and is retained without
power. You can change the configuration at any time. The unit performs a reset after
the configuration has been changed and stored.
Note:
The menus in this section show a typical device. Your device may
have different configuration options.
This chapter includes the following topics:
Topic
Page
Accessing Setup Mode
4-1
Server Configuration (Network Configuration)
4-4
Channel 1 Configuration (Serial Port Parameters)
4-5
E-mail Settings
4-17
Expert Settings
4-17
Security Settings
4-19
Factory Defaults
4-21
Exit Configuration Mode
4-23
Accessing Setup Mode
Using a Telnet Connection
To configure the unit over the network, establish a Telnet connection to port 9999.
Note:
You can also use DeviceInstaller to access Telnet. Select the device
from the main window list, and click the Telnet icon
. If you use the
Telnet icon on the DeviceInstaller toolbar, skip steps 1 and 2.
XPort™ User Guide
4-1