Lantronix XPort - Manual (Page 41)

Using Setup Mode for Configuration
Channel (Port) Password
This parameter appears only if the channel (port) password option is enabled in
Disconnect Mode. If the option is enabled, you can set a password on the serial port.
E-mail Settings
Note: You can change these settings via Telnet or serial connections only,
not on the Web-Manager. To configure e-mail settings via DeviceInstaller,
see E-mail Notification in the DeviceInstaller User Guide on the CD.
The unit can send an e-mail to multiple recipients when a specific trigger event
occurs. There are three separate triggers, based on any combination of the
configurable pins (PIO) when selected as user I/O functions. You can also use a two-
byte serial string to initiate a trigger.
Figure 4-14. E-mail Settings
E-mail Setup
E-mail setup requires you to set up the e-mail server location as follows:
Mail server The IP address in decimal-dot notation.
Unit The user name used by the XPort to send e-mail messages.
Domain The domain name of your e-mail server.
Recipient 1 Full e-mail address of the recipient.
Recipient 2 Full e-mail address of the second recipient.
XPort™ User Guide 4-17