Lantronix XPort - Manual (Page 45)

Using Setup Mode for Configuration
Enabling Your Serial Device on the Lantronix web site ( www.lantronix.com )
for more instructions and sample code.
The following export agreement is required for the optional encryption:
I agree that I will not export or re-export this software file to a national
resident of Cuba, Iran, Iraq, Libya, North Korea, Sudan, Syria or any other
country to which the United States has embargoed goods; or to anyone on
the US Treasury Department's list of Specially Designated Nationals and
Blocked Persons, US Commerce Department's Table of Denial Orders and
Entitles List, or the US State Department's Debarred List. By receiving this
software, I am agreeing to the foregoing and I am representing and
warranting that I am not located in, under the control of, or a national or
resident of any such country or on any such list.
Enable Enhanced Password
This setting defaults to the N (option), which allows you to set a 4-character
password that protects Setup Mode by means of Telnet and web pages. The Y (Yes)
option allows you to set an extended security password of 16-characters for
protecting Telnet access.
Disable Port 77F0 (Hex)
Port 77F0 is a setting that allows a custom application to query or set the three XPort
configurable pins when they are functioning as general purpose I/O (GPIO). You may
want to disable this capability for security purposes. The default setting is the N (No)
option, which enables GPIO control. The Y (Yes) option disables the GPIO control
interface.
Factory Defaults
Select 7 to reset the unit’s Channel 1 configuration, e-mail settings, and expert
settings to the factory default settings. The server configuration settings for IP
address, gateway IP address, and netmask remain unchanged. The configurable
pins’ settings also remain unchanged. The specific settings that this option changes
are listed below.
Channel 1 Configuration
Baudrate 9600
I/F Mode 4C (1 stop bit, no parity, 8 bit, RS-232C)
Own TCP port number 10001
Connect Mode C0 (always accept incoming connection; no active
connection startup)
Hostlist retry counter 3
Hostlist retry timeout 250 (msec)
Start character for serial channel 1 0x0D (CR)
All other parameters 0
Expert Settings
TCP keepalive 45 (seconds)
ARP cache timeout 600 (seconds)
XPort™ User Guide 4-21