Disconnmode, Flush mode (buffer flushing), Disconnmode -14 – Lantronix XPort User Manual
Page 38: Flush mode (buffer flushing) -14
Using Setup Mode for Configuration
DisConnMode
This setting determines the conditions under which the unit will cause a network
connection to terminate.
Note:
In DisConnMode (Disconnect Mode), DTR drop either drops the connection or
is ignored.
Table 4-27. Disconnect Mode Options
Disconnect Mode Option
7
6
5
4
3
2
1
0
Disconnect with DTR drop
(6)
1
Ignore
DTR
0
Telnet mode and terminal type
setup
(1)
1
Channel (port) password
(2)
1
Hard disconnect
(3)
0
Disable
hard
disconnect
1
State LED off with connection
(4)
1
Disconnect with EOT (^D)
(5)
1
(1) The XPort sends the "Terminal Type" upon an outgoing connection.
(2) A password is required for a connection to the serial port from the network.
(3) The TCP connection closes even if the remote site does not acknowledge the disconnection.
(4) When there is a network connection to or from the serial port, the state LED turns off instead of blinking.
(5) When Ctrl D or Hex 04 is detected, the connection is dropped. Both Telnet mode and Disconnect with
EOT must be enabled for Disconnect with EOT to function properly. Ctrl D is only detected going from the
serial port to the network.
(6) When DTR transitions from a high state to a low state, the network connection to or from the serial port
drops.
Flush Mode (Buffer Flushing)
Using this parameter, you can control line handling and network buffers with
connection startup and disconnect. You can also select between two different
packing algorithms.
4-14
XPort™ User Guide