Lantronix XPort - Manual (Page 26)

Using Setup Mode for Configuration
1. From the Windows Start menu, click Run and type the following command,
where x.x.x.x is the IP address, and 9999 is the unit’s fixed network configuration
port number:
telnet x.x.x.x 9999
Note: Be sure to include a space between the IP address and 9999.
2. Click OK . The following information displays.
Figure 4-1. MAC Address
3. To enter the Setup Mode, press Enter within 5 seconds. The configuration
settings display, followed by the setup menu options.
Figure 4-2. Setup Menu Options
Change Setup:
0 Server configuration
1 Channel 1 configuration
3 E-mail settings
5 Expert settings
6 Security
7 Factory defaults
8 Exit without save
9 Save and exit Your choice
?
4. Select an option on the menu by entering the number of the option in the Your
choice ? field and pressing Enter.
5. To enter a value for a parameter, type the value and press Enter, or to confirm a
current value, just press Enter.
6. When you are finished, save the new configurations (option 9). The unit reboots.
Using the Serial Port
To initially configure the unit through a serial connection:
1. Connect a console terminal or PC running a terminal emulation program to your
unit's serial port. The default serial port settings are 9600 baud, 8 bits, no parity,
1 stop bit, no flow control.
2. To enter Setup Mode, reset the unit, either by pushing the red reset button, or
cycling the unit's power (power off and back on). The self-test will begin. You
have one second
to enter three lowercase x characters (xxx).
Note: The easiest way to enter Setup Mode is to hold down the x key at
the terminal (or emulation) while resetting the unit.
3. At this point, the screen display is the same as when you use a Telnet
connection. To continue, go to step 4 in Using a Telnet Connection on page 4-1.
4-2 XPort™ User Guide