Pioneer CMX-3000 - Manual (Page 33)

<DRB1308>
33
En/Sp
English
Espa
ñ
ol
Troubleshooting
Appendix
Cleaning the Jog Dial
To clean the PLAYER wipe with a polishing or a soft, dry cloth. For
stubborn dirt, moisten a soft cloth with a weak solution of neutral
detergent (diluted in five to six parts water), wring the cloth well, and
wipe away the dirt. Use a dry cloth to wipe the surface dry. Applying
alcohol, paint thinner, benzene, insecticides, or other stringent
substances to the jog dial may cause the markings or finishing of the dial
to peel or become discolored, and the use of any such substances
should accordingly be avoided.
<DRB1308>
33
En
Error Code
E-72 01
E-83 01
E-83 02
E-83 03
E-91 01
Description
Player unable to read TOC data.
Player unable to play back currently
inserted disc.
Mechanical operation has failed to
complete within specified time interval.
Possible cause and recommended action
Disc is cracked.
= Recommended action: replace disc.
Disc is soiled or dirty.
= Recommended action: clean disc.
If other discs play normally, the problem is with the
disc itself.
Dust or some other form of foreign particles have
found their way into disc insertion slot.
= Recommended action: remove dust or other
foreign particles.
Error Type
TOC READ ERROR
PLAYER ERROR
MECHANICAL TIME OUT
Error Message Display
When the CMX-3000 CD player is unable to operate properly, an error code is displayed on the display panel. Check the error code
displayed against the following table and take the recommended action to correct the error. If an error code other than any of the error
codes listed in the table below is displayed or if the same error code is displayed even after corrective action has been taken, contact
your nearest Pioneer Service Station or contact the store from which you purchased your player for assistance.
Published by Pioneer Corporation.
Copyright © 2001 Pioneer Corporation.
All rights reserved.
÷ There may be times when the CMX-3000 fails to operate properly as a result of static electricity or some other form of interference from an outside
source. If any such problem occurs, turn off the power to the CMX-3000, wait for the currently inserted disc to come to a full stop, and then turn on
the power again to see if that fixes the problem in question.
÷ The CMX-3000 cannot be used to replay partially-written CD-R or CD-RW discs.
÷ The CMX-3000 cannot be used to replay non-standard-shaped discs or any discs other than 5 inch/12 cm discs or 3 inch/8 cm discs which have
been inserted into an 3 inch/8 cm disc adapter. (Note that attempting to replay such discs may result in damage or breakdown.)
÷ The BPM value measured by the CMX-3000 may differ from the BPM value recorded on a CD or from our DJ mixer, but this difference is a result
of differences in the BPM value measurement method; not a result of a fault with the player.