Pioneer DEH-P55BT - Manual (Page 59)

# FAD : 0 is the proper setting when only two
speakers are used.
# When the rear output setting is R-SP :S/W,
you cannot adjust front/rear speaker balance.
Refer to Setting the rear output and subwoofer
controller on page 65.
3 Push MULTI-CONTROL left or right to
adjust left/right speaker balance.
Each time
MULTI-CONTROL is pushed left or
right, the left/right speaker balance moves to-
wards the left or right.
L 15 to R 15 is displayed as the left/right
speaker balance moves from left to right.
Using the equalizer
The equalizer lets you adjust the equalization
to match car interior acoustic characteristics
as desired.
Recalling equalizer curves
There are six stored equalizer curves which
you can easily recall at any time. Here is a list
of the equalizer curves:
Display Equalizer curve
SUPER BASS Super bass
POWERFUL Powerful
NATURAL Natural
VOCAL Vocal
CUSTOM Custom
FLAT Flat
! CUSTOM is an adjusted equalizer curve
that you create.
! When FLAT is selected no supplement or
correction is made to the sound. This is
useful to check the effect of the equalizer
curves by switching alternatively between
FLAT and a set equalizer curve.
1 Press AUDIO to select POWERFUL.
Press AUDIO until POWERFUL appears in the
display.
# If the equalizer curve has been previously se-
lected, the curve of that previously selected will
be displayed instead of
POWERFUL.
2 Push MULTI-CONTROL left or right to
select the equalizer.
Each time
MULTI-CONTROL is pushed left or
right, equalizer curves are selected in the fol-
lowing order:
SUPER BASS
—POWERFUL—NATURAL—
VOCAL
—CUSTOM—FLAT
Adjusting equalizer curves
You can adjust the currently selected equalizer
curve setting as desired. Adjusted equalizer
curve settings are memorized in
CUSTOM.
1 Press AUDIO to select EQ.
Press AUDIO until EQ appears in the display.
2 Push MULTI-CONTROL left or right to
select the equalizer band to adjust.
Each time
MULTI-CONTROL is pushed left or
right, equalizer bands are selected in the fol-
lowing order:
EQ-L (low)
—EQ-M (mid)—EQ-H (high)
3 Push MULTI-CONTROL up or down to
adjust the level of the equalizer band.
Each time
MULTI-CONTROL is pushed up or
down, the level of the equalization band in-
creases or decreases.
+6 to
–6 is displayed as the level is increased
or decreased.
# You can then select another band and adjust
the level.
Audio Adjustments
En
59
English
Section
12