Panasonic KX-FT78HK - Manual (Page 65)

Remote Operation (KX-FT78 only)
-65-
Other remote operations
Erasing a specific message
Press {*}{4} while listening to the
message you want to erase.
L A long beep and 3 short beeps will
sound. The unit will then play back the
next message.
Erasing all the messages
Press {*}{5} to erase all the messages.
L A long beep and 3 short beeps will
sound.
Monitoring the room
Press {6} to monitor the sound for about 30
seconds in the room where the unit is
installed.
L After 30 seconds, a beep sounds. To
continue monitoring, press {6} again
within 10 seconds.
Recording a marker message
After playing back the recorded messages,
you can leave an additional message.
1. Wait for 3 beeps indicating the end of the
remote operation.
2. Hear 1 beep.
3. Wait about 10 seconds.
4. Hear the voice guide or hear 1 beep.
5. Leave a message.
Re-recording a greeting message
You can change the contents of the
TAD/FAX greeting message.
1. Press {7} to start recording.
L A long beep will sound.
2. Speak clearly up to 16 seconds.
L If you pause for over 2 seconds, 6
beeps will sound and the recording will
stop. Repeat from step 1 within 10
seconds.
3. When finished recording, press {9}.
L The new greeting message will be
played.
Answering device remote operation
1. Call your unit.
2. Press the remote operation ID
during the greeting message.
3. Press the remote command key.
Key Remote command
{ 9} Stops re-recording of a
greeting message
Key Remote command {*}{ 4} Erases a specific message
{ 0} Skips the greeting
message {*}{ 5} Erases all messages
{ 1} Repeats a message { 8}{0} Changes to TEL mode
{ 2} Skips a message { 8}{1} Turns on message transfer
{ 4} New message playback { 8}{2} Turns off message transfer
{ 5} All message playback { 8}{3} Turns on pager call
{ 6} Room monitor { 8}{4} Turns off pager call
{ 7} Re-records a greeting
message {*}{*}{*}{ 9} Activates fax function
FT74-78HK.book Page 65 Friday, June 28, 2002 9:45 AM