Panasonic PV DR2714 - Manual (Page 70)

70
Transfer ( Dubbing) from DVD
For assistance, please call : 1-800-211-PANA(7262) or, contact us via the web at:http://www.panasonic.com/contactinfo
PRESS AND HOLD DUBBING
FOR 3 SEC TO START
1
With both VCR and DVD in Stop mode, hold down
VCRĸ for about 3 seconds after OSD below is
displayed.
Dubbing stops automatically when disc playback is finished or at
tape end.
„ To end dubbing
Press STOP.
• When playback (source) side ends and unit enters Stop mode,
or, if dubbing is stopped due to an error, a message will briefly
appear.
DUBBING
VCRȰDVD
EP XP
2
Dubbing begins. Information is displayed on the
screen and sub display.
Sub Display
One Touch Dubbing (DVD ĺ Tape)
DVD side:
• Insert a disc containing programs to be dubbed.
VHS side:
• Insert a cassette with record tab intact.
• Recording will be done from tape beginning. Check tape contents
carefully as all existing recordings will be completely dubbed over.
• Select the recording mode. (SP or EP).
Preparation
You can transfer (dubbing) programs recorded on a disc* 1 onto a
tape with one stroke of the button.
In One-Touch Dubbing, all contents on the disc are automatically
dubbed onto the tapes. If you want to transfer (dubbing) from the
desired point, see “Manual Dubbing” on next page.
* 1 Available discs for transfer (dubbing) onto tape are DVD-RAM and
DVD-R. Most DVD videos cannot be dubbed because they are
copy-guarded.
STOP
DVD
VCR REC
VCR ĸ
PLAY
PAUSE
„ Only the following operations are allowed while
transferring (dubbing):
• Stopping transfer (dubbing) by pressing STOP.
• Changing channels.
- During dubbing, you can select and watch TV stations using
NUMBER keys and Channel Ÿź keys. To switch back to the
dubbing picture, press DVD or VCR. If it is the dubbing picture, CH is
not displayed.
• Selecting input mode by pressing INPUT.
• Turning unit ON/OFF by pressing POWER. (Dubbing will
continue even if power is turned off.)
• Changing audio mode by pressing AUDIO.
Notes:
• While One Touch Transfer (Dubbing) is activated, timer recording cannot
be started.
• When the transfer (dubbing) is not started or not executed, the
“DUBBING” indicator blinks for about 7 seconds. Check if the unit is
properly prepared.
SPEED
AUDIO
NUMBER
keys
CH Ÿź
INPUT
VCR