Panasonic PV DR2714 - Manual (Page 71)

71
Dubbing
Operation
• When appears on the screen while a button is being pressed, it means that the corresponding operation is prohibited by
the unit or the disc.
Note:
• VCR REC button is nonfunctional during DVD playback search and
during Chase playback.
DUBBING
VCRȰDVD
EP XP
Manual Dubbing (DVD ĺ Tape)
Sub Display
1
Set remote to DVD mode.
2
Press PLAY. Playback starts. Recording start point
is located.
3
Press PAUSE at desired dubbing start point.
4
Press SPEED to set recording speed. (Select SP or
EP mode.)
5
Press VCR REC. Disc playback starts automatically
and dubbing to VCR starts. Dubbing information is
displayed on the screen and sub display.
DVD side:
• Insert a disc containing programs to be dubbed.
• Select Audio mode. (See page 54.)
VHS side:
• Insert a cassette with record tab intact.
• Make sure there is enough tape remaining
Preparation
You can specify the position to start transfer (dubbing) of the
program recorded on the disc* 1 to the tape.
In One-Touch Dubbing, all contents on the disc are automatically
dubbed onto the tapes.
* 1 Available discs for transfer (dubbing) onto tape are DVD-RAM and non-
finalized DVD-R. Most DVD videos cannot be dubbed because they are
copy-guarded.
„ To end dubbing
Press STOP.
• When playback (source) side ends and unit enters Stop mode,
or, if dubbing is stopped due to an error, a message will briefly
appear.
„ Only the following operations are allowed while
transferring (dubbing)
• Turning unit ON/OFF by pressing POWER.
• Stopping transfer (dubbing) by pressing STOP.
• Selecting input mode by pressing INPUT.
• Changing channels.
- During dubbing, you can select and watch TV stations using
NUMBER keys and Channel Ÿź keys. To switch back to the
dubbing picture, press DVD or VCR. If it is the dubbing picture, CH is
not displayed.
Notes:
• While Manual Dubbing (DVD ĺ Tape) is activated, timer recording
cannot be started.
• When the transfer (dubbing) is not started or not executed, the
“DUBBING” indicator blinks for about 7 seconds. Check if the unit is
properly prepared.