Plasmon LIBRARIES D2175 - Manual (Page 47)

Plasmon D875 - D2175 User Manual Menu System
Document Revision E Page 45
Table 8. Library Status Menu Selections
Menu Selection Description
1 Config Information Allows viewing only of library configuration settings.
1 Unit Information/Config
To view the storage slot count, drive count, and firmware revision.
2 Serial Number
To view the serial number assigned to the library.
3 Date and Time
To view the current date and time settings.
4 SCSI Bus Config To view the current SCSI Bus configuration
5 Changer Address To view the changer SCSI ID.
6 Drive Addresses To view individual drive SCSI IDs.
7 Changer Options To view changer options:
Disable Tray Return (default Y or N)
Tray Return on Power (Y or default N)
Disable Autoload/Eject (Y or default N)
Ignore Recovery Errors (Y or default N)
Limit Recovery (Y or default N)
Enable All Uattn (Y or default N)
8 Passwords
This option is not available when library is online.
9 RMI Information
Not supported.
2 Status Information Allows viewing only of library status.
1 Element Status To view which elements (slots, drives, pickers, or I/E station) are populated
by media.
2 Drive States To view the power on/off state of a drive.
3 Power-On Hours
To view total hours of power to library. Useful for preventive maintenance.
Cannot be reset.
4 Unit Cycle Count To view total cycle count since first startup. Cannot be reset.
5 Drive Load Counts To view total drive loads since last reset of count.
6 Function Counts To view total function counts since last reset of count.
Lift Movement Count
Picker 1 Movement Count
Picker 2 Movement Count
Change Picker Count
Pivot L/R Col Movement Count
Mag Door Open Count
Disk Flip Count
Cumul Lift Dist
Cumul Picker Dist
Cumul Pivot Rotation