Plasmon LIBRARIES D2175 - Manual (Page 73)

Plasmon D875 - D2175 User Manual Appendix D
Document Revision E Page 71
3 24V out of range during
check main circuit
board cable check
19 1 Power supply fail One of the power sup-
ply has been removed
Power sup-
ply, or supply
cable Replace power supply, check
supply cable
2 Power supply fan has
failed
3 Power supply power
failure
1A 1 SCSI bus isola-
tion Time out waiting for iso-
late bus command to
complete
2 Time out waiting for iso-
late bus to complete
while restoring bus
1B 1 Too few power
supplies More than one drive
interface board and
only one power supply Add power supply
22 1 Bus already iso-
lated Service drives, isolate
request and bus
already isolated
2 Restore drives, isolate
request and bus
already isolated
23 1 Bus not isolated Service drives, un-iso-
late request and bus
not isolated
2 Restore drives, un-iso-
late request and bus
not isolated
31 1 Drive not
installed Positioning to drive Drive inter-
face cables Replace cables or drive inter-
face circuit board or configure
in drive
3 Checking a move from
a drive
4 Checking a move to a
drive
Error
Code
(hex)
Sub-
code
Error
Description
Subcode
Description
Compo-
nent
Corrective Action