Plasmon LIBRARIES D2175 - Manual (Page 30)

Library Installation Plasmon D875 - D2175 User Manual
Page 28 Document Revision E
Library Packing Instructions
This section is provided in case it is necessary to ship the library (without expansion bays) to another
location or back to Plasmon. Instructions on how to pack the expansion bays is provided later in this
chapter. These procedures must be followed.
CAUTION
Plasmon libraries must be shipped in the original packaging.
Shipping a unit in anything other than the manufacturers
packaging voids the warranty. Replacement packaging is
available from Plasmon.
The library must be parked before packing the system.
Follow these steps to pack the library for shipping:
1. While parking, the library prompts for insertion of the MTE packaging material.
2. Insert the first piece of foam under the Rotation Station. Place this foam so the tab is on
the top left side when viewed from the back of the library.
3. Insert the second piece of foam under the MTE being careful not to damage the vertical
path emitter. Place this foam so the cut-out is on the left when viewed from the back of the
library.
Figure 16. Packing the D875 - D2175 Libraries (a)
Foam tab
1 s t P i e c e o f
P a c k a g i n g
Foam
2 n d P i e c e o f
P a c k a g i n g
Foam