Panasonic AJ-D455P - Manual (Page 15)

15
ON
OFF
POWER
EJECT
REC PLAY
DVCPRO
DV
FF STOP REW
CTL/TC/UB/
REMAIN
RESET
CH CONDITION
LEVEL
HEADPHONES
CH 1
AUDIO
REC LEVEL
ON
OFF
CH 1 MIX CH 2
AUDIO MONITOR
SUPER
DVCPRO/DV SDI ANALOG
Y PB PR CMPST S-VIDEO
SDI AES/EBU
ANALOG REMOTE
LOCAL
MENU
PAGE
TC PRESET FILE
SET
DIAG
VIDEO IN AUDIO IN
CH 2
INT
EXT
TC
1 5
2, 3
Setup (default settings)
The unit’s major settings are performed by making selections on menus.
The setting menus appear on the TV monitor when the TV monitor and VIDEO OUT 3
connector in the unit's connector area are hooked up. The menus can be output to the SDI
OUT 3 connector as well when the AJ-YA455P component serial interface board is used.
Changing the settings
1
Press the MENU button.
The setup menu appears on the TV monitor and setup menu No. appears on the
counter display. (If the setup has already been performed, the screen showing the
changes made last will appear.)
2
Press the cursor buttons ( , ) and select the item to be set.
The cursor (
∗
) on the menu screen moves and the item No. on the display flashes.
• When the button is pressed, the item No. is incremented for 001
→
002
→
003
→
004
→
and so on; when the button is pressed, the item No. is decremented.
3
Press the cursor buttons ( , ) at the position where the change is to be made.
The menu screen and display setting No. now flashes.
When the
button is pressed, the setting No. is incremented; when the button is
pressed, it is decremented.
4
Repeat steps 2 and 3 to change other items.
5
Press the SET button.
The changes are now stored in the memory.
• To return the items to the settings established before the changes were made, press
the MENU button without pressing the SET button.
To return the setup settings to the factory (initial) settings, press the RESET button
while the menu is displayed.
The following message is displayed.
SETUP-MENU INIT SET
YES<PLAY>/NO<STOP>
When the PLAY button is pressed, the factory settings are restored.
<Notes>
• When the RESET button is
pressed to return to the
factory settings, the factory
settings are restored only for
the user file currently being
used and other user files are
not affected.
• The changed SYSTEM menu
contents are stored in the
memory even if the MENU
button is pressed.