Panasonic AJ-D455P - Manual (Page 26)

26
Setup menus
USER menu
<INTERFACE>
Item Setting
No.
Superimposed
No.
Superimposed Description
display display
201 9P SEL 0000 OFF
0001 ON
202 ID SEL 0000 OTHER
0001 DVCPRO
0002 ORIG
204 RS232C SEL 0000 OFF
0001 ON
205 BAUD RATE 0000 300
0001 600
0002 1200
0003 2400
0004 4800
0005 9600
206 DATA 0000 7
LENGTH 0001 8
207 STOP BIT 0000 1
0001 2
208 PARITY 0000 NON
0001 ODD
0002 EVEN
209 RETURN 0000 OFF
ACK 0001 ON
The underline on the setting item denotes the initial setting.
This selects whether the 9-Pin connector functions when the
REMOTE/LOCAL switch has been set to REMOTE.
0: Do not function
1: Function
This selects the ID information which is returned to the
controller.
0: 20 25H
1: DVCPRO’s, own ID is returned (F0 33H).
2: The unit’s own ID (A0 3CH) is returned.
<Note>
Set “ORIG” only when the unit is connected with a Panasonic
controller (such as the AJ-A900, optional accessory).
These settings are for selecting whether the RS-232C con-
nector is to function when the REMOTE/LOCAL switch is set
to REMOTE.
0: Connector does not function.
1: Connector functions.
These settings are for selecting the RS-232C communication
speed (baud rate).
These settings are for selecting the RS-232C data length.
(Unit: bit)
These settings are for selecting the RS-232C stop bit length.
(Unit: bit)
These settings are for selecting the none, odd or even for the
RS-232C parity bit.
0: Parity bit is not used.
1: An odd number of bits is used for the parity system.
2: An even number of bits is used for the parity system.
These settings are for selecting whether the ACK code is to be
returned when a command is received from RS-232C.
0: ACK code is not returned.
1: ACK code is returned.