Panasonic AJ-D455P - Manual (Page 24)

24
Setup menus
USER menu
<OPERATION>
Item Setting
No.
Superimposed
No.
Superimposed Description
display display
101 SHTL MAX 0000
Ч
16
0001
Ч
32
0002
Ч
60
102 FF. REW 0000
×
32
MAX 0001
Ч
60
0002
Ч
100
103 AUDIO 0000 OFF
MUTE 0001 ON
104 REF 0000 OFF
ALARM 0001 ON
106 PLAY 0000 0
. .
. .
DELAY . .
0015 15
107 CAP.LOCK 0000 2F
0001 4F
109 EJECT EE 0000 EE
SEL 0001 BLACK
0002 GRAY
110 F/R EE SEL 0000 EE
0001 TAPE
111 STOP EE 0000 EE
SEL 0001 TAPE
112 AUTO REW 0000 OFF
0001 ON
The underline on the setting item denotes the initial setting.
This sets the maximum speed for shuttle operations.
0: 16
×
normal speed
1: 32
×
normal speed
2: 60 × normal speed
<Note>
When a DV or DVCAM cassette is used, the 32
× speed will be
set even if “
×
60” has been selected as this item’s setting.
This sets the maximum speed for FF and REW operations.
0: 32
×
normal speed
1: 60 × normal speed
2: 100
×
normal speed
<Note>
When a DV or DVCAM cassette is used, the 32
× speed will
be set regardless of what has been selected as this item’s
setting.
This sets the status until the audio signal is output when
operation switches from the stop or search modes to the play
mode.
0: The time until the audio is output is shortened.
1: The audio is output after the status stabilizes.
<Note>
When set to 0 (OFF), the sound in the initially output part is
incomplete. Therefore, this setting is not recommended for
broadcasts.
This selects whether to warn the operator when the
REF.VIDEO signal has not been connected.
0: Warning is not given.
1: Warning is given by the flashing STOP lamp.
This set the play delay time in frame increments.
This selects the capstan lock mode.
0: 2F mode
1: 4F mode
For selecting the video and audio output status when the tape
is ejected.
0: EE mode
1: Video blackens, audio mutes.
2: The images appear in gray, and the sound is muted.
This selects whether EE mode or playback mode is to be used
during FF/REW operations.
0: EE mode
1: Playback mode
This selects whether EE mode or playback mode is to be used
during stop mode.
0: EE mode
1: Playback mode
<Note>
This setting is complied with even in the standby OFF mode.
However, the images will appear in gray when “TAPE” has
been selected.
This selects whether to rewind the tape automatically to the
tape start when the tape end is detected.
0: The tape stops at the tape end.
1: The tape is rewound to the tape start.