Panasonic AJ-D455P - Manual (Page 34)

34
Setup menus
USER menu
<VIDEO> (continued)
Item Setting
No.
Superimposed
No.
Superimposed Description
display display
612 WIDE 0000 AUTO
SELECT 0001 WIDE
0002 NORMAL
613 VIN SETUP 0000 THRU
0001 CUT
620 Pb/Pr OUT 0000 M II
LV 0001 B-CAM
The underline on the setting item denotes the initial setting.
This selects the operation to be conducted in response to the
WIDE information.
0: During recording, if the S1-VIDEO input signals contain
WIDE information, the WIDE information is recorded on the
tape.
During playback, if WIDE information is on the tape, it is
added to the S1-VIDEO output signals.
1: During recording, the WIDE information is recorded on the
tape regardless of whether the S1-VIDEO input signals
contain the WIDE information.
During playback, the WIDE information is added to the S1-
VIDEO output signals regardless of whether the WIDE
information is on the tape.
→
Forced WIDE ON
2: During recording, the WIDE information is not recorded on
the tape regardless of whether the S1-VIDEO input signals
contain the WIDE information.
During playback, the WIDE information is not added to the
S1-VIDEO output signals regardless of whether the WIDE
information is on the tape.
→
Forced WIDE OFF
<Note>
This item is effective during recording at the start of the
recording and during playback at all times. Therefore, when its
setting has been changed during recording, the MENU
contents will be changed but no change will occur in the actual
operation.
This selects whether the composite signal is to be recorded
with setup or without setup.
0: When recording signals with no setup.
1: When recording signals with 7.5% setup.
<Note>
When recording composite signals, be sure to double-check
whether the signals are to be recorded with or without setup.
For selecting the analog component output level.
0: M
II level
1: Betacam level