Peavey X-VCA - Manual (Page 43)

p. 43
group module 3
group module features
The Group modules are physically configured in pairs, four pairs making up
the eight Groups. Each of the eight Group modules offer identical functions
for the eight associated Aux Masters, Audio Groups, and VCA Groups.
Each group module includes the following sections:
*Aux output control
*Matrix send
*Groups dynamics control with gain reduction meter
*Audio group with 100mm fader and VCA control
*VCA master group with 100mm fader
aux output control
AUX STEREO PAIR switch Each odd / even pair of Aux masters has an
Aux Stereo Pair switch for globally configuring the associated auxes for Level
/ Level or Level / Pan operation
The associated odd / even pair of Auxes function as individual, discrete
mono aux sends.
The associated odd / even pair of Auxes function as a stereo pair. The
odd numbered Aux acts as a Level control for the stereo pair and the even
numbered Aux acts as a pan control
mute
Mute switch
See LOCAL MICROPROCESSOR CONTROL section
Aux master output level (1 - 8)
The AUX MASTER output level controls set the levels that appear at the
corresponding AUX output connectors on the rear-panel.
Talk to (1 - 8)
Adds the TALKBACK system output to the associated AUX output.The
level of the TALKBACK signal is set by the TALKBACK level control in the MAS-
TER section.
solo switch
Pressing this momentary switch will include (illuminate) or exclude (not-illu-
minated) the channel from the consoles solo system.
See SOLO FEATURES section.
write-in label
This label may be written on with a grease-marker, or dry-erase pen and later
wiped clean. Masking tape may also be placed on this surface, if desired. If you
write on it with a "Sharpie", you may have trouble getting the writing off. If this is
the case, your best bet is to wipe the label off with isopropyl (rubbing) alcohol.