Peavey X-VCA - Manual (Page 87)

p. 87
5
rear panel features
Left, Right and Mono insert points
Separate send and return 1/4" TRS jacks are provided for inserting external signal
processors into the Left, Right and Mono outputs.The insert points are located
after the Low pass filters and before the EQ sections.
insert send
This jack serves as an output which gets patched to the input of a sig-
nal processor. Plugging a 1/4" TRS plug into this jack does not break the signal
flow of the master output..This output jack is ground-compensated.
insert return
The output of a signal processor is patched to jack. It can accept a bal-
anced or unbalanced signal. Plugging a 1/4" TRS plug into this jack breaks the signal
flow of the master output.
Stereo Program In jacks (left and right)
These two (left and right) 1/4" TRS jacks are used to bring balanced or
unbalanced stereo signals into the Stereo Program In section.Typically, they can be
the return from a stereo signal processor or the output of a two track playback
device.
Left, Right and Mono master outputs
These three balanced male XLR connectors carry the Left, Right and Mono
outputs.
Monitor outputs (left and right)
These two balanced male XLR connectors carry the Left and Right Monitor
outputs 4.
Assist output
This balanced male XLR connector carries a signal that is made up of the
post fader Left and Right master outputs, summed together. Pressing the LCR to
Outputs button will add the Mono master output to this summed signal. Internal
jumpers can be set to make the master feeds pre fader instead of post fader.
Midi IN and OUT
These jacks allow the microprocessor system to communicate with MIDI gear.
See the section on the Microprocessor for more information.
DC In
This 7 pin connector is used to connect the power supply interconnect cable to
the console.
master control section