Peavey X-VCA - Manual (Page 73)

p. 73
5
matrix sends
The master control section contains two sets of Matrix sends.The first set is used
to dial the Mono master signal into the four matrix busses.The second set is used
to dial external signals into the four matrix busses.
mono matrix 1–4 sends
These level controls are used to dial the MONO signal into the correspond-
ing matrix busses.
matrix sends post mono
MONO fader setting has no effect on the group-to-matrix level controls
1–4.
The MONO fader is introduced into the signal path and will control the sig-
nal level.When MONO is muted, the MONO signal to matrix 1-4 is muted as
well.
external input to matrix 1–4 sends
On the rear panel there are four balanced 1/4" TRS connectors.They are
labeled Matrix 1 through 4, one input for each matrix bus.These level controls are
used to dial external sources into the corresponding matrix.
matrix 1 in to all 4 switch
The signals fed into the four external matrix inputs appear at their corre-
sponding matrix 1-4 pots, ready to be dialed onto the four matrix buses.
The signal fed into external matrix input 1 is routed to each of the matrix 1-
4 pots, ready to be dialed into the four matrix busses. Signals fed into matrix
inputs 2, 3 and 4 are disregarded.
master control section