Peavey X-VCA - Manual (Page 63)

4
p. 63
left / right & mono master modules
Output EQ features
Independent stereo and mono output EQ sections are provided on X-VCA.The EQ
consists of 5 bands and a fixed High pass filter.The High and Low bands are shelving
EQ and the High Mid, Mid and Low mid are full parametric. Although the left and right
signals are processed separately, the paramaters are set in tandem by common front panel
controls.
high frequency—HF (shelving eq)
Boost / Cut (inner knob)15dB boost and cut.
Frequency (outer knob) Continuously sweepable between 1kHz and 20kHz
high mid—HM
Bandwidth A Q range of 3.0 to 0.7 (0.5 octave to 2.0 octave) is available.
Boost / Cut (inner knob)15dB boost and cut.
Frequency (outer knob) Continuously sweepable between 400 Hz and 8 kHz.
mid—MID
Bandwidth A Q range of 3.0 to 0.7 (0.5 octave to 2.0 octave) is available.
Boost / Cut (inner knob)15dB boost and cut.
Frequency (outer knob) Continuously sweepable between 200 Hz and 4 kHz.
Low mid—LM
Bandwidth A Q range of 3.0 to 0.7 (0.5 octave to 2.0 octave) is available.
Boost / Cut (inner knob)15dB boost and cut.
Frequency (outer knob) Continuously sweepable between 60 Hz and 1.2 kHz.
Low frequency—LF (shelving eq)
Bandwidth A Q range of 3.0 to 0.7 (0.5 octave to 2.0 octave) is available.
Turning the control full clockwise switches operation to a plus/minus shelving mode.
Boost / Cut (inner knob)15dB boost and cut.
Frequency (outer knob) Continuously sweepable between 40 Hz and 800
kHz.
eq on
Equalizer is on. This switch is used to activate the EQ section and can be used
to make A/B comparisons between "flat" and eq'd signals.
high-pass filter—HPF
The high pass filter HPF has a fixed cut off frequency of 40Hz and a 24dB per octave
slope.
HPF
High-pass filter is on.