Peavey X-VCA - Manual (Page 51)

p. 51
group module 3
audio group control features
This section provides standard features for the Group bus masters. Signals that are
assigned to the Audio groups are summed together to make up the audio Groups. A
full featured dynamics control section (see previous section) can be engaged for pro-
cessing the summed group signals.These signals can be assigned to the Left, Right and
Mono buses and appear at the Group output jacks on the rear panel.
group pan
The PAN pot is used to position the group signal within the stereo left / right
field.The signal must be assigned to left and right in order for the PAN control to
have any effect.
safe preview
Safe Preview LED
See LOCAL MICROPROCESSOR CONTROL section
mute
Mute switch
See LOCAL MICROPROCESSOR CONTROL section
audio group fader
This 100mm fader controls signal levels to the associated audio group outputs as
well as signals assigned to the left/right and mono (center) mix buses.
mono assignment switch
Post fader assignment of signal to the mono mix bus.
L-R stereo assignment switch
Post fader/post pan pot assignment of signal to the left and right stereo mix
buses.
Group insert ON switch
The Insert point is located after the group summing amp and before the
dynamics control system. External signal processors can be inserted into the
group via 1/4" TRS connectors (send and return) on the rear panel.The
SEND signal is unbalanced and the RETURN can accept both unbalanced
and balanced signals.
Insert is switched OUT. Any signal coming into the Insert RETURN
jack is ignored.The Insert SEND jack can be used to derive a pre dynamics,
pre fader output from the group without interrupting the group's normal
signal flow.
Insert is switched IN.The Insert RETURN jack is active. A signal
processor patched to the groups insert is switched into the signal path.
signal/peak LED
This dual color LED responds audio Group's signal level. It illuminates green
with varying brightness in proportion to the pre-fader audio signal.When the sig-
nal approaches clipping, either pre or post fader, the LED illuminates red.
solo switch
Pressing this momentary switch will include (illuminate) or exclude (not-illu-
minated) the channel from the consoles solo system.
See SOLO FEATURES section.
LED
LED