Peavey X-VCA - Manual (Page 81)

p. 81
5
talkback and solo features
talkback control
The talkback section provides the facilities to take either an external input signal, or
an internally generated ping noise signal and route it to the consoles outputs.This is
useful for making announcements from the mix position and for performing system
diagnostics when other signal sources are not readily available.
Talkback control level
This control sets the level of the talkback signal, whether it is from the exter-
nal input or consists of the internal pink noise generator.
Pink noise
The talkback control section can get it's source signal from three places.The first
two are the female XLR mic inputs, one is located on the front panel in the Master
control section.The other is located below the consoles armrest, on the right side.
The third available source signal is the pink noise generator.The source is deter-
mined by the Pink Noise switch. For more information on the Talkback XLR mic
inputs, see the master control section rear panel descriptions.
The talkback control section gets it's source signal from either, or both of the
Talkback female XLR mic inputs.
The talkback control section gets it's source signal from the internal pink noise
generator.
TB ON - Talk back on
This "soft" switch activates the Talkback section.The Talkback section must be acti-
vate in order for any of it's features to work.
Tap switch once - This will toggle the Talkback section on and off.Tap once to
turn it on, when you're done tap it again to turn it off.
Press and hold - The switch works as a momentary button. Press it and hold it
for more than two seconds.While the button is down, the Talkback section is acti-
vated.When you release the button, the Talkback section shuts off.
Headphone level
This control sets the level that appears at the two headphone jacks. One jack
is located on the consoles front panel, next to the TB mic input, and the other jack is
located below the armrest.
LCR to Outputs button
The signals that appears at the Alt outs, the Monitor outs and the headphones
do not include the Mono, or center output signal.
The signals that appear at the Alt outs, the Monitor outs and the headphones
include the Mono, or center output signal.
master control section