Peavey X-VCA - Manual (Page 59)

4
p. 59
left / right & mono master modules
features
Aside from their Left / Right and Mono assignments, the X-VCA Left / Right and
Mono master modules contain identical features. One module is devoted to the
Left and Right stereo mix and the other module is devoted to the Mono mix.
Both modules contain the following sections:
* Matrix Output Control
* Matrix Send 1 though 4
* Output EQ
* RMS Output Limiter
* 100mm Faders
* Microprocessor Mute Controller
* Solo
Matrix output control
The Left / Right master module contains Matrix Master 1 and the Mono master
module contains Matrix Master 2.
mute
Mute switch
See LOCAL MICROPROCESSOR CONTROL section
Matrix master output level
The MATRIX MASTER output level controls set the levels that appear at
the corresponding MATRIX output connectors on the rear-panel.
Talk to
Adds the TALKBACK system output to the associated MATRIX output.The
level of the TALKBACK signal is set by the TALKBACK level control in the MAS-
TER section.
solo switch
Pressing this momentary switch will include (illuminate) or exclude (not-illu-
minated) the channel from the consoles solo system.
See SOLO FEATURES section.
write-in label
This label may be written on with a grease-marker, or dry-erase pen and later
wiped clean. Masking tape may also be placed on this surface, if desired. If you
write on it with a "Sharpie", you may have trouble getting the writing off. If this is
the case, your best bet is to wipe the label off with isopropyl (rubbing) alcohol.