Phonetics 1108 - Manual (Page 100)

Sensaphone ® Model 1108 User’s Manual
88
Communications / Dial-out: Problem
Solution
Cause
6.
The Model 1108 and telephone answering device (sharing the same line) answer incoming calls simultaneously
.
The Model 1108
’s number of Rings Until
Answer is set to equal the number of rings set for the telephone answering device.
Change the number of Rings Until
Answer
for the Model 1108. Refer to Chapter 4, Section 4.5.
5.
The Model 1108 dials out correctly but fails to audibly recite its alarm message when you answer the call.
V
oice Reps is set to zero.
Reprogram
V
oice Reps to 1 or greater
.
Refer to Chapter 4, Section 4.10.
4.
The Model 1108 recites the alarm message or Status Report over the telephone, but is silent at the installation site.
The local v
oice mute feature is in ef
fect.
Deactivate local voice mute. Refer to the programming steps in Chapter 4, Section 4.9. When calling the Model 1108, and the
TA
D
is disabled, allow the telephone to ring 10 times. Refer to Chapter 6, Section 6.1.3, and Chapter 4, Section 4.6.3.
Y
ou did not allo
w the telephone to ring
10 times.
Note:
If the
T
AD (telephone
answering device) is disabled, the telephone rings ten times before the Model 1108 answers. If the
T
AD is enabled, the
telephone rings once before the Model 1108 answers the call.
3.
The Model 1108 will not answer the telephone for Callback Acknowledgement.
(Continued from previous page)