Phonetics 1108 - Manual (Page 28)

Sensaphone ® Model 1108 User’s Manual
16
3.2 Preparation for Programming
Read complete instructions in Chapter 2: Installation, and make
sure to follow these steps first:
1. Plug the AC adaptor into the 120 VAC outlet.
2. Install the batteries.
3. Connect the Model 1108 to a telephone line.
When these steps are completed, the Model 1108 is fully
operational and able to monitor temperature, high sound,
AC power failure and battery backup condition; it can also be
called on the telephone for a Status Report or used for listening
to on-site sounds from any remote location. Now, the unit is
ready for programming.
3.3 Quick-Start Programming Steps
Step 1: Set Configuration of Inputs
The Model 1108 will scan the 8 external inputs and determine
if they are N.O. (normally open), N.C. (normally closed), or
Temperature. If external sensors are added, make sure they are
in their normal positions before proceeding—refer to
Chapter 5, Section 5.1.
1. Press STANDBY to place the Model 1108 in Standby
mode.
RUN
STANDBY
2. If you have external sensors available, wire the sensors to
the inputs on the back of the Model 1108 (see Chapter 2,
Section 2.10). Otherwise, skip this step and move to
step 3.
3. Press RUN. The red light glows when the Model 1108
returns to Run mode.
RUN
STANDBY