Phonetics 1108 - Manual (Page 78)

Sensaphone ® Model 1108 User’s Manual
66
5. Press ENTER.
ENTER
TONE
PM
5.11 High Sound Alarm Enable/Disable
The Model 1108 monitors sound through the built-in
microphone. When the sound level suddenly exceeds the
programmed high sound limit, the Model 1108 will respond to
an alert condition. The increased sound level must continue
throughout the programmed recognition time. The default for
high sound alarm is enabled (on).
NOTE
The microphone is also used for listening to
on-site sounds. Refer to Chapter 4, Section 4.7.
Disabling the sound alarm does not affect
listen-in capability.
5.11.1 Changing Enabled/Disabled High Sound Alarm
1. Press SENSOR ON/OFF.
SENSOR
ON/OFF
2. Press SOUND. The Model 1108 will say “Off” to
indicate disabled or “On” to indicate enabled.
9
LISTEN TIME
SOUND
3. Repeat key sequence to change settings.
5.12 Exit Delay
When tripping an alarm is unavoidable, yet a true alert
condition has not actually occurred, the alarm response,
including dial-out, can be temporarily suppressed.