Selecteur tapis/plancher, Selector carpet-bare floor, Filter changing/cleaning – Panasonic MC-V7582 User Manual

Page 21

Advertising
background image

- 21 -

- 36 -

Se debe colocado el selector en la
posición para BARE FLOOR (TOOLS)
cuando pasa la aspirador en los suelos
sin alfombra y cuando se usan las
herramientas.

Los agitadores no rotan en la posición

BARE FLOOR (TOOLS).

Se debe colocar el selector en la
posición para CARPET cuando pasa la
aspiradora en los suelos con alfombra.

Para operar, ponga el mango en la
posición vertical. Pise el selector Piso
Sin Alfombra.

Rote el selector a la posición de atrás
BARE FLOOR (TOOLS).

Para seguir limpiando la alfombra rote el
selector hacia adelante a la posición
CARPET.

Siempre tenga cuidado al seleccionar
cualquier posición para asegurar que el
selector esté movido rápido y por
completo a la posición deseado.

Selector carpet-bare floor

Sélecteur tapis/plancher

➢Le sélecteur doit être à la position

« BARE FLOOR (TOOLS) » lors de
l’utilisation sur les planchers ou des
accessoires.

➢Les agitateurs ne tournent pas lors de la

sélection de la position « BARE FLOOR
(TOOLS) ».

➢Le sélecteur doit être à la position

« CARPET » lors du nettoyage des
moquettes.

➢Pour utiliser, mettre l'aspirateur à la

position verticale. Poser le pied sur le
sélecteur tapis/plancher.

➢Amener le sélecteur vers l'arrière pour le

mettre à la position « BARE FLOOR
(TOOLS) ».

➢Pour retourner au nettoyage de

moquette, amener le sélecteur vers
l'avant pour le mettre à la
position « CARPET » .

➢S’assurer de pousser complètement et

rapidement le sélecteur à la position
désirée.

Filter Changing/Cleaning

Check primary filter frequently and

clean when dirty.

Remove the dust bin assembly as

outlined in the DUST BIN CLEANING
section and empty contents of dust
bin.

Make sure dust bin is clean before

filter is removed.

Grasp filter, rotate counter-clockwise

and lift out.

Clean primary filter by gently tapping

over a trash container. Tap on several
sides to ensure best cleaning. (Rinse
with water only as needed).

The filter may be cleaned by tapping it

on a firm surface or by rinsing it under
a faucet. Rinse with water only, do not
use detergent or soap. Allow filter to
dry 24 hours before putting it back into
the dust bin.

When the cleaning of the filter no

longer restores vacuum suction to full
power you need to replace the filter.

Before replacing the filter it is a good

idea to clean the inside of the dust bin
and lid area.

When replacing filter, carefully slide

filter over cleaning cam.

Rotate filter clockwise until slots lock

onto tabs in cover.

Close bottom lid, MAKING SURE LID IS

SECURELY LATCHED.

Reinstall dust bin as outlined in Dust

Bin Cleaning Section.

Note: Under normal use and care, your filter
can be expected to last up to 5 years.

Primary Filter

Filtre primaire

Filtro primario

Primary

Filter

Filtre

primaire

Filtro

primario

Cleaning

Cam

Came de

nettoyage

Cleaning

cam

Slot

Fente

Ranura

Locking Tab

Languette

de blocage

Tabulatión el

bloquer

Advertising