Printronix H-SERIES P7000 - Manual (Page 22)

22
Chapter 3 The Control Panel
JOB SELECT
In offline mode, this key allows for fast selection of any of the previously
stored configurations. Pressing this key causes the printer to cycle through
the following messages: Load Config., Factory Config, Load Config 1, Load
Config 2, Load Config 3,...,Load Config 8.
ENTER
When navigating the configuration menus, ENTER selects the currently
displayed option value as the active value. An asterisk (*) appears next to the
active value on the display. ENTER is also used for starting and stopping
printer tests and generating a configuration printout.
NOTE: The ENTER key must be unlocked in order to function.
See UP + DOWN, below.
The ENTER key lock and unlock function can be configured to be a
key combination other than
=
+
>
(see page 105).
UP or DOWN (
=
or
>
)
Moves up or down between levels in the configuration menus and makes
vertical forms adjustment. After pressing VIEW, press
=
or
>
to adjust the
paper up or down in 1/72 inch increments for fine vertical forms alignment.
When the printer is in offline mode, press
=
or
>
to move through levels in the
configuration menus.
UP + DOWN (
=
+
>
)
Locks and unlocks the ENTER key.
NOTE: The ENTER key lock and unlock function can be configured to be a
key combination other than
=
+
>
(see page 105).
PREV or NEXT (
;
or
<
)
Moves between the options on the current level of configuration menu. In the
configuration menu, press
;
to scroll backward or press
<
to scroll forward
through the menu selections on the same level.
PREV + NEXT (
;
+
<
)
When both keys are pressed simultaneously, the printer will reset to the
power-up configuration and reset its internal state (in offline mode).
Ribbon Life Indicator
The second line of the LCD displays the remaining life of the currently
installed ribbon. The default settings for this feature should match the
requirements for most applications; no special user setup is needed. If your
particular application requires darker printing or can tolerate lighter printing,
the ribbon end point can be adjusted as appropriate. Please refer “Ribbon
End Point” on page 99.