Printronix P9000 Series - Manual (Page 125)

6-27 Programming
Character Set Select: ECMA 94 Latin 1 Extended
ASCII Hex Decimal
P-Series SFCC OSET;n
Serial N/A N/A N/A
Purpose Selects the Extended Character Set and the print mode and pitch at which the
extended character will print. Valid only in the ECMA 94 Latin 1 Extended
Character Set; otherwise, this command is ignored.
Comment n ranges from 0 to 12 to select the print mode/pitch combinations available
from Table 6-5. All other values will result in an error message. In OSET
mode, values outside the range in Table 6-5 will produce an error message
(Command Line Error Messages are listed on page 6-3).
OSET is valid only when the ECMA 94 Latin 1 character set has been selected
from the control panel. OSET will be ignored if the IBM PC, Multinational,
or DEC Multinational Character Sets are active.
Extended characters will print at the print mode and pitch selected by the
OSET command, even if that mode and pitch differs from the currently seĆ
lected print mode and pitch. If the print mode differs between the extended
and primary characters, the first character in the data stream selects the print
mode at which that line will print. Different pitches can be printed on the
same line.
Table 6-5. Print Modes/Pitches Available Using P-Series OSET
(ECMA 94 Latin 1, Extended Character Set Only)
n Print Mode/Pitch Select
0 Bar Code DP 10 cpi
1 Multinational DP 10 cpi
2 Multinational DP 12 cpi
3 Multinational NLQ 10 cpi
4 Greek DP 10 cpi
5 Greek DP 12 cpi
6 Greek NLQ 10 cpi
7 Graphics DP 10 cpi
8 Graphics NLQ 10 cpi
9 Scientific DP 10 cpi
10 Scientific DP 12 cpi
11 Scientific NLQ 10 cpi
12 Multinational at Primary Character Set Mode
and Pitch